Advertisement
MON/SCAN
Monitor function
When this feature is activated, the radio can receive very low and weak signals. This is
very useful when you need to talk but the distance is as far as the maximum range pos-
sible; with the monitor feature you can extend the coverage of the radio.
The disadvantage is the reception of loud background noises.
Activation/Deactivation: Keep pressed MON/SCAN till the display shows "Rx".
SCAN function
The SCAN mode monitors the busy channels.
It is used to check the traffic radio on all the channels before transmitting and allows the
unit to stop on a channel that someone is talking on. When the radio stops on a busy
channel, the scan will resume after about 5 seconds.
To activate the SCAN function
1.
Push MON/SCAN.
2.
While the scan mode is operating, if you push the ▲/▼ controls you can choose
the scanning direction.
To deactivate it:
Press MON/SCAN or PTT.
Recharge
When the batteries are discharged, the icon
the recharge as soon as possible. The icon blinks only if the radio is turned on.
ATTENTION
Alkaline batteries cannot be recharged.
Do not recharge the radio without the rechargeable batteries.
For the very first time, we recommend to recharge the radio for 10/12 hours.
Insert the batteries into the radio. Plug the USB supplied in the package into the USB
port of the radio. The icon with its bars will be displayed to indicate that the radio is being
charged. Once the batteries are fully charged the bars of the icon
We recommend to disconnect the power supply (disconnect the USB cable).
Note: the USB cable must be connected to devices with a charge current of 500mAh at
least.
10 |
starts blinking: it is necessary to start
will be steady.
XT30 PRO instruction guide
Auto power save
XT30 PRO is supplied with an automatic current economy circuit. If the transceiver
receives no signal for more than 10 seconds, the "power save function" automatically
activates. The battery life may increase by up to 50 %.
Accessories
XT30 PRO is provided with a MIC/SPK jack for the connection of external accessories
such as mikes or headsets. This plug is 2-pin type and is compatible with all Midland
accessories.
Troubleshooting and radio reset
XT30 PRO is designed to provide you with years of optimal performance. If for some
reason problems arise, refer to this chapter before contacting a service centre in your
region.
Reset
If your transceiver experiences a logical malfunction (improper symbols on the display,
blocking of functions, etc.), it may not be experiencing a true failure, but rather a pro-
blem caused by external factors. For example, it may have an incorrect setting brought
on by a noise or spikes in the electrical system during battery recharging. In such cases,
you can reset the transceiver to its factory-programmed settings, by resetting all pa-
rameters:
• Turn off the transceiver
• Keep pressed the ▲ button and turn on the radio at the same time. All the functions
will be reset ex-factory.
Before you go ahead with the reset, we recommend that you take note of all the set-
tings you have carried out as they will be deleted.
XT30 PRO instruction guide
| 11
Advertisement
