Annex.: Error Code Definition Table - Cloud Drive CDC6 Display Manual

Annex.: Error Code Definition Table

Error
Code
Throttle not back to origin position
04
(Stop at high level position)
05 Throttle malfunction
07 Over-voltage protection
08 Motor Hall cable malfunction
09 Motor Phase cable malfunction
Motor temperature reach to the high
10
temperature protection point
11 Motor Temp. Sensor malfunction
12 Current sensor malfunction
13 Battery Temp. is too high
14 Controller Temp. is too high
15 Controller Temp. Sensor malfunction
21 Speed sensor malfunction
22 BMS communicate malfunction
23 Headlight malfunction
24 Headlight sensor malfunction
Torque signal malfunction of torque
25
sensor
Speed signal malfunction of torque
26
sensor
30 Communication malfunction
Different protocols may cause different error code definition list, please check with the e-Bike factory.
If there is something wrong with the 5-cores cable between the controller and display:
Business Cooperation
Jim@clouddrive.tech
Definition
Empower and serve the global eBike industry
1. Check if throttle is back to the origin position firstly, then check
if the connecting cable is loosed,
2. If everything goes well, replace a new throttle.
1. Check if throttle is back to the origin position firstly, then check
if the connecting cable is loosed,
2. If everything goes well, replace a new throttle.
1. Check if the battery voltage is beyond the bearing range of
controller;
2. Replace a new matching battery.
Check if motor cable is loose and re-plug out/in motor cable;
Check if motor cable is loose and re-plug out/in motor cable;
Power off the display, wait until the motor temperature returns to
normal, then go on cycling.
Replace a new Temp. Sensor.
Replace a new sensor.
Stop cycling and wait the temperature returns to normal.
Stop cycling and wait the temperature returns to normal.
Replace a new controller.
1. Check if the speed sensor connection is normal;
2. If connection is normal, then replace a new speed sensor.
1. Check if the battery connection is normal;
2. If connection is normal, then replace new battery.
1. Check if the headlight connection is normal;
2. If connection is normal, then replace new headlight.
1. Check if the headlight sensor connection is normal;
2. If connection is normal, then replace new headlight sensor.
1. Check if the torque connection is normal;
2. If connection is normal, then replace new torque sensor.
1. Check if the torque connection is normal;
2. If connection is normal, then replace new torque sensor.
1. Check if the cables connected to display are loose, or if the
connectors are broken;
2. Check if the cables connected to controller are loose, or if the
connectors are broken;
3. Check if the cable jacket is broken;
4. Reconnect the display cables;
5. Replace the controller or display.
www.clouddrive.tech
Solutions
Page 18 of 19