Table of Contents
Advertisement
Hard Disk Backup Function
Backing Up and Restoring Data
36
<To create a backup area and divide hard disk into two partitions, for OS and data>
Select [2], enter the partition size (GB), and press Enter .
• You can cancel this operation by pressing 0 .
• The data partition size will be the maximum settable size less the number entered above.
The maximum settable size will differ depending on models.
[At the time of purchase]
The usable hard disk area
9 At the confirmation message, press Y .
The backup area is then created.
10 When the message [You must reboot in order to enable the Backup function.] appears, remove
the Product Recovery DVD-ROM, and press any key to restart the computer. The computer is
restarted, then the backup process will begin.
11 When the message [[Backup] is complete] appears, press Ctrl + Alt + Del to restart the
computer.
CAUTION
Do not press Ctrl + Alt + Del until the message is displayed.
12 After logging on to Windows, a message will appear advising that a new device has been
installed and that the computer must be restarted to enable the settings. Select [Yes] to restart
the computer.
NOTE
The [Boot] menu in the Setup Utility is set to start up from the CD/DVD drive. Change this
setting if necessary.
The next time the backup or restore functions are executed, follow the procedure for
ing Up and Restoring Data
CAUTION
Before executing the backup function, execute a disk error check (
Do not interrupt the backup or restore functions before completion, for example by turning
off the power or pressing Ctrl + Alt + Del , as this may prevent Windows from
starting up, or may cause data to be lost so that the backup and restore functions cannot be
executed.
1 Turn the computer on, and press F2 while [Panasonic] boot screen is displayed.
The Setup Utility will start up.
If a password has been set, enter the Supervisor Password or the User Password.
2 Select [Exit] menu, then select [Hard Disk Backup / Restore] and press Enter .
At the confirmation message, select [Yes], and press Enter .
[After the backup area is created]
Can be accessed from
Windows (Two partitions).
" (
below).
The backup area
Cannot be accessed
from Windows.
" Back-
page 34).
Advertisement
Table of Contents
