Table of Contents
Advertisement
for Ventrac Power Units, Attachments, & Accessories
•
Ensure the attachment or accessory is locked or fastened securely to the power unit before operating.
•
Ensure that all bystanders are clear of the power unit and the attachment before operating. Stop the ma-
chine if someone enters your work area.
•
Always be alert to what is happening around you, but do not lose focus on the task you are performing.
Always look in the direction the machine is moving.
•
Look behind and down before backing up to be sure of a clear path.
•
If you hit an object, stop and inspect the machine. Make any necessary repairs before operating the ma-
chine again.
•
Stop operation immediately at any sign of equipment failure. An unusual noise can be a warning of equipment
failure or a sign that maintenance is required. Make any necessary repairs before operating the machine again.
•
If equipped with a high/low range feature, never shift between high and low range while on a slope. Always
move the machine to level ground and engage the parking brake before shifting range.
•
Do not leave the machine unattended while it is running.
•
Always park the machine on level ground.
•
Always shut off the engine when connecting the attachment drive belt to the power unit.
•
Never leave the operator's station without lowering the attachment to the ground, engaging the parking
brake, shutting off the engine, and removing the ignition key. Make sure all moving parts have come to a
complete stop before dismounting.
•
Never leave the machine unattended without lowering the attachment to the ground, engaging the park-
ing brake, shutting off the engine, and removing the ignition key.
•
Only operate in well-lit conditions.
•
Do not operate when there is a risk of lightning.
•
Never direct the discharge of any attachment in the direction of people, buildings, animals, vehicles, or
other objects of value.
•
Never discharge material against a wall or obstruction. The material may ricochet back toward the operator.
•
Use extra caution when approaching blind corners, shrubs, trees, or other objects that may obscure your vi-
sion.
•
Do not run the engine in a building without adequate ventilation.
•
Do not touch the engine or the muffler while the engine is running or immediately after stopping the en-
gine. These areas may be hot enough to cause a burn.
•
Do not change the engine governor settings or over-speed the engine. Operating the engine at excessive
speeds may increase the hazard of personal injury.
•
To reduce the hazard of fire, keep the battery compartment, engine, and muffler areas free of grass, leaves,
excessive grease, and other flammable materials.
•
Clear the working area of objects that might be hit or thrown from the machine.
SAFETY
General Safety Procedures
Safety - 7
Advertisement
Table of Contents
