CAB PS11 Assembly Instructions Manual
  1. Manuals
  2. Brands
  3. CAB Manuals
  4. Accessories
  5. PS11
  6. Assembly instructions manual

CAB PS11 Assembly Instructions Manual

Present sensor
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Assembly Instructions
PS11
Present Sensor
Made in Germany

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PS11 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for CAB PS11

Summary of Contents for CAB PS11

  • Page 1 Assembly Instructions PS11 Present Sensor Made in Germany...
  • Page 2 Assembly Instructions Present Sensor PS11 Edition: 03/2016 - Art.-No. 9009836 Copyright This documentation as well as translation hereof are property of cab Produkttechnik GmbH & Co. KG. The replication, conversion, duplication or divulgement of the whole manual or parts of it for other intentions than its original intended purpose demand the previous written authorization by cab.

  • Page 3: Intended Use

    Time 1.2 Intended Use • This device is an exclusive option for cab Hermes C printers to dispense labels approved by the manufacturer. Any other use or use going beyond this shall be regarded as improper use. The manufacturer/supplier shall not be liable for damage resulting from unauthorized use;...

  • Page 4: 2 Product Description

    Product Description The Present Sensor PS11 allows to operate the Hermes C in peel-off mode without applicator. • In the Automatic mode a label will be printed and dispensed after sending a print job. After removing the label from the peel position the next label will immediately be transported to the peel position.

  • Page 5: Product Description

    Product Description max.10 Figure 2 Label in peel position The reflective sensor detects the label (6) about 15 mm from the left edge of the liner (5). Attention! To guarantee the function of the sensor, the distance between the label and the left edge of the liner may not exceed 10 mm.
  • Page 6 Mounting Note! Keep the original packaging for later transports. Attention! Damage and failure in function by dust, dirtiness and humidity.  Use the device only in a clean and dry environment. Figure 3 Mounting 1. Switch off the printer. 2. Connect the plug (3) to the peripheral port (4). 3.

  • Page 7: Setting The Operation Mode

    Operation 4.1 General Settings  Activate the peel-off mode in the software. In direct programming use the "P" command.  Programming Manual of the printer.  Configure the peel-off parameters.  5 Printer Configuration 4.2 Setting the Operation Mode Attention! ...

  • Page 8: Automatic Mode

    3. Send a print job. A label will be printed and transported the peel position. The reflective sensor in the PS11 detects the label and interrupts the transport until the label will be removed. 4. Remove the label from the peel position.

  • Page 9: Printer Configuration

    Printer Configuration Note! The peel-off parameters can only be set with the Present Sensor PS11 installed. Note! For more information about the configuration procedure  Configu- ration Manual of the printer.  Press the menu key.  Select Setup > Machine param. > Demand sensor...
  • Page 10 Reference to the EU Declaration of Conformity The Present Sensor PS11 complies with the relevant fundamental regulations of the EU Rules for Safety and Health: • Directive 2014/30/EU relating to electromagnetic compatibility • Directive 2011/65/EU on the restriction of the use of certain hazardous...

Table of Contents