Table of Contents
Advertisement
WARNING
Disconnect the electrical supply before servicing or cleaning the unit. Failure to
do so could result in electrical shock or personal injury from cleaner suddenly
starting.
Belt Cover
Couvercle de la
courroie
Cubierta de
la correa trasera
Lower Plate
Plaque inférieure
Base inferior
Lower Plate
Plaque inférieure
Base inferior
Belt Cover
Couvercle de la
courroie
Cubierta de
la correa trasera
Electrical Shock or Personal Injury Hazard
Removing and Installing Lower Plate
Latches
Loquets
Lengüetas
Tabs
Latches
Languettes
Loquets
Lengüetas
Lengüetas
Before servicing any parts, disconnect
vacuum cleaner from electrical outlet.
Place paper under nozzle whenever
lower plate is removed to protect floor.
Place handle in upright position and
turn vacuum cleaner over to expose
lower plate.
Release lower plate by pressing two
(2) latches inward.
Remove lower plate and remove any
residue that may exist in belt area.
Lift belt cover to replace belt if
necessary. (See Replacing Belt page
30).
Close the rear belt cover and reinstall
lower plate by hooking front end of
lower plate into the front of nozzle
housing.
Make sure all wires are routed
properly and not pinched.
Press lower plate into place then
push two (2) latches outward.
- 28 -
Advertisement
Table of Contents
