Page 2
V2.0 February 2023 Layout, photographs and text: RUFF CYCLES GmbH, Regensburg, Germany Text passages are provided with courtesy of HNF GmbH The mentioned brand names are subject to copyrights and are the property of their legitimate owners even without special indication. Any reprint or copy, even only in extracts, is only permitted with our expressed written consent.
CONTENTS Your Vehicle 6.8.2. Checking the Brake Pads 6.9. Setting the Headlight Range 1.1. Intended Use Cleaning and Maintenance 1.2. Vechile Overview Transport on/by Car 1.3. Delivery Scope Technical Data 1.4. Assembly of Accessories 9.1. Component List Commissioning 9.2. Weights 2.1.
YOUR VEHICLE Content and Symbols in this User Manual This User Manual contains important information for enhancing safety and pro- YOUR VEHICLE longing service life of the Pedelec as well as lasting fun with your Lil‘Missy. We congratulate you on the purchase of a Pedelec with BOSCH driving techno- Any neglect of the contents of this User Manual may lead to damages to the logy.
Page 5
YOUR VEHICLE YOUR VEHICLE Intended use is also limited by: Check if required active and passive illumination devices have been installed ac- cording to the safety regulations applicable in your country. Required illumination devices can be purchased on our offical website. The technical design safety •...
YOUR VEHICLE COMMISSIONING 1.3. DELIVERY SCOPE Loosen it by releasing the 2 screws (2) of the stem. Now you can adjust the compression of the steering bearing with the ahead bolt. Re-tighten the stem screw with a torque of 6-7 Nm •...
COMMISSIONING COMMISSIONING 2.3. REMOVAL/INSTALLATION OF THE BATTERY 2.6. SWITCHING ON/OFF THE LAMP Removing the battery: • Make sure that the engine is on • Before removing the battery, ensure that • By pressing the button “+“ for a few seconds, the system is disconnected.
BEFORE EACH RIDE BEFORE EACH RIDE BEFORE EACH RIDE with alcohol. Do not use a conventional brake disc cleaning solution! The pressure point is the lever position of the travel at which the brake is engaged. If bra- 3.1. CHECKING THE TIRES kes function smoothly —...
BEFORE EACH RIDE OPERATING THE BIKE 3.6. CHECKING THE SCREW CONNECTIONS OPERATING THE BIKE Before each ride, check the firmness of screw connections for 4.1. CHAIN GEAR DERAILLEUR • Quick release of the front wheel With the shifting system, you can adjust the gear ratio using a shifter lever. •...
OPERATING THE BIKE ERGONOMIC SETTING 4.3. BRAKE SYSTEM ERGONOMIC SETTING Your Pedelec is equipped with hydraulic brake discs for a fast and safe stopping 5.1. BRAKE LEVER action. Use both brakes simultaneously for an optimal and safe braking. The left brake lever has an effect on the front wheel brake, the right brake lever has an effect on the rear wheel brake.
ERGONOMIC SETTING MAINTENANCE 5.1.3. ADJUSTING BRAKE LEVER DISTANCE 6.1. WEAR PARTS LIST The brake lever distance setting should al- low you to operate the brake lever by the first The following parts of your Pedelec are subject to wear according to their use. phalanxes of both fingers positioned on the This wear is not covered by the warranty.
MAINTENANCE MAINTENANCE Every 310 miles (500 km) Stress Battery life is reduced by a high demand on the engine output (strong stepping • Check bearing clearance of steering up, high supporting levels). • Check bearing clearance of hubs • Check bearing clearance of pedals Environmental temperature at storage •...
MAINTENANCE MAINTENANCE • Open the quick release by turning over the handle • Loosen the nut a few turns at the other end of the quick release. The front wheel now slides out from the dropout of the fork • Insert the transportation lock between the brake pads When the wheel is dismounted, do not activate the hydraulic brake discs.
MAINTENANCE MAINTENANCE 6.6.4. INSTALLING THE FRONT WHEEL 6.7. CHAIN DERAILLEUR SETTINGS • Remove the transportation lock between the brake pads • In the first picture you can see the chain tail which has an upper (A) and • Thread the front wheel into the fork carefully. Make sure that the brake disc lower (B) stop skids into the brake pads •...
MAINTENANCE CLEANING AND MAINTENANCE 6.8.2. CHECKING THE BRAKE PADS CLEANING AND MAINTENANCE Brake pads must be changed when they • If required, clean the Pedelec with water (but not a water jet!) using a soft • Have a width of only 0.098 inches (2.5 cloth or soft brush mm) (height of friction lining incl.
TECHNICAL DATA TECHNICAL DATA 9.2. WEIGHTS LIABILITY FOR MATERIAL DEFECTS Battery Weight 300 Wh 2,5 kg A statutory liability for material defects is applicable for a period of 24 months as from the day of purchase. Battery Weight 500 Wh 2,7 kg The prerequisite for the assertion of material defects liability shall be the submis- Tare Weight incl.
Packaging materials shall be collected separately and directly disposed of according to local collection schemes. Take the used battery to an E-bike dealer or send it in for disposal in the hazardous waste packaging at RUFF CYCLES GmbH. RUFF CYCLES GmbH - Disposal -...
Need help?
Do you have a question about the Lil'MISSY and is the answer not in the manual?
Questions and answers