Advertisement
KSA-i400 Owner's Reference
Unpacking / Placement / AC Power Guidelines
Unpacking
The KSA-i400 is very heavy and requires two strong people to lift it and position it.
Place the shipping box on a firm level surface. Lift off the top of the shipping box and remove the small
cardboard box located in the center of the protective foam. This box contains a power cord and a
12V trigger cable. Remove the top protective foam. The unit can now be lifted out of the bottom part
of the shipping box and placed in the desired location.
Placement
The KSA-i400 may generate substantial heat while in operation and is intended for use indoors in a
typical residential environment. Place it on a firm level surface where it will not be exposed to
excessive heat, humidity, dust, or moisture of any kind. Krell recommends that it be placed in open
air and not in an enclosed cabinet or rack. The bottom, sides, and top must remain unobstructed in
order to maintain adequate air flow. Do not place it directly on a deep pile carpet. It should not be
placed on top of other equipment nor should other equipment be placed on top of it. Please contact
Krell if it must be placed in a rack as forced air circulation will be required.
AC Power Guidelines
The KSA-i400 requires a dedicated AC circuit rated at a minimum of 20 amps for 100-120VAC
operation or 13 amps for 220-240VAC operation. Do not use extension cords, adapters, or power
strips. Krell does not recommend the use of power conditioners with the KSA-i400.
© 2022 by Krell Industries LLC. All rights
reserved.
Page 4 of
15
Advertisement
