Operation Steps - Skymen MECHANICAL Series Instruction Manual

OPERATION STEPS

Before Operating Your Cleaner
Start ultrasonic cleaning
S series: At first setting, the time is random.
Touch "Time+" or "Time-" to set time, press
"On/off" the ultrasonic active and the
machine start to countdown.
Plus Series Description: Time starts to countdown in minutes. The progress bar indicator flashes to show that the ultrasound starts to work.
When the countdown is over, the ultrasound stops working, the progress bar indicator recover light, press the knob again during the work,
When ultrasound stops working, the progress bar indicates Light stops flashing. The next boot,display of timer will default last setting.
1. Add cleaning liquid
Add appropriate amount of cleaning solution to the cleaning tank accord-
ing to the cleaning. Ensure that the liquid level is not lower than the inner
tank height by 2/3 when the heating is turned on. Use flammable liquids
such as alcohol, gasoline, etc. It is forbidden to heat. Long-term vibration
will cause liquid increase in temperature, beware of fire!
2. Open power
Plug the cleaner into a grounded outlet. Turn on the power switch at the
tank back, then machine is power on.("O" is closed, and " " is open)
PLUS Series: Turn on the power ，in the LOGO breathing light standby
state, wake up by any operation
MECHANICAL SERIES
Start(ULTRASONIC), clockwise rotate to choose the time you
required between 0~30 min. When the indicator light is on and
make "ZIZI" sound,it shows ultrasonic operation work OK.
Time
PLUS series: At first setting, the time is
random, progress bar light on, Turn the
rotary knob clockwise to increase time ;
Turn counterclockwise to decrease time.
Correspondingly the two digits on the left of
the display change accordingly, and the
time setting done well. Press the rotary
knob, ultrasonic start working.
05
www.skymen.cc
Actual
Temperature
℃
Set
Temperature
℃