Common Solutions - SJRC F22S Instructions Manual

COMMON SOLUTIONS

1. The mobile device and remote control cannot be connected.
Check the status of control signal icon on the APP if changed.
2. The image transmission is jammed or easily out of control and disconnected.
① Adjust the antenna angle to align with the aircraft, and ensure no
obstruction in the middle position.
② Change the flight area. Please DO NOT fly near high buildings or signal
towers.
③ Update the latest firmware of the aircraft.
3. The aircraft hovers unsteadily.
① Change the flight area. Please DO NOT fly near high buildings or signal
towers.
② Conduct aircraft compass calibration and horizontal calibration.
③ Judge whether the strong wind affects the flight or not.
④ Judge whether the fan blade and the arm are deformed or not.
4. The GPS accuracy of the aircraft is not accurate or cannot pass the GPS
accuracy test.
① Go to an open area outdoors where GPS signal can be searched 6 or
more satellites.
② Walk around the aircraft at close range.
③ Replace the mobile device.
④ Do not test it under high buildings.
5. The battery cannot be charged.
Re-plug and unplug the charger or re-load and unload the battery.
6. Short flight time.
Overcharge or discharge the battery, also the battery life reducing can be
caused by the high-temperature environment. It is recommended to store
the remaining 60% of the battery power and recharge it fully before using.
7. Excessive inclination angle or abnormal problem of the UAV PTZ checking.
Re-start the aircraft on the flat ground to PTZ calibration.
①
Check the PTZ status if it works or not.
②
Choose the"
③
8.PTZ initialization fails
Please take the PTZ protection cover off before turn on the power of the
aircraft, then put it on the flat ground to PTZ calibration.
9. Unclear shooting.
① Check whether the camera protective film is removed or not.
② Use it under the good light environment.
③ Set shooting parameters from the camera setting in the APP.
10. The camera is misty.
① Wet weather causes fog on the camera. Replace the storage place of
the aircraft.
② Place desiccant in the protective cover of camera during storage.
11. Pictures or videos taken are lost.
When recording a video, you must end the recording operation, otherwise
the video may be damaged or lost.
"on the APP to restore the PTZ to original factory setting.
26