SJRC F22S Instructions Manual page 16

APP Status: Please place the aircraft on a level ground and hold the aircraft
stationary until the head of the pendant recallocates.
NOTICE: Fly in open areas, tall structures and large metal structures may
affect the accuracy of the onboard compass and GPS system.
Please search the GPS signal in the open areas.
App Status: "Reset to factory Setting / Level level calibration"
Precautions: Please put the aircraft on the horizontal ground for the restore
factory setting.Otherwise it may affect the flight attitude.
Step 6: Compass Calibration--Part 2
— Pick up the aircraft from the bottom, head
of the aircraft facing down and follow your
body for a complete circle (360°).
Now remote control makes "DI"sound.
— White light + red light (front) of the aircraft--
Solid on.
Step 7: GPS Searching(DO NOT use GPS Mode
indoor)
— Reposition the aircraft on a horizontal surface.
— Blue light (rear) + White light (front) of the
aircraft keep slowly flashing. It means the
GPS enters into the state of Satellite Search.
— It takes a few minutes to complete this step.
— Blue light (rear) and White light (front) of the
aircraft shows Solid on, this means the GPS
satellite searching is successful.
Step 8: Calibrate Gyroscope
— Push the joysticks into the 11 & 1 o'clock
position.
— Blue light (rear) + White light (front) of the
aircraft: Keep flashing quickly.
— App Drone Status: "Gyroscope calibrated"
Step 9: Reset to factory Setting / Level
calibration
— Push the throttle lever of the remote control
to the "7" o'clock position and push the
direction lever to the "1" o'clock position.
— Blue light (rear) + White light (front) of the
aircraft: Keep flashing quickly.
13