Panasonic WV-CW484S Operating Instructions Manual page 8

Do not aim the apparatus at strong light
sources.
A light source such as a spot light causes a
blooming (light bleeding) or a smear (vertical
lines).
Smear
Blooming
About the dehumidifying device
• The camera has dehumidifying device to
keep the inside at low moisture level,
preventing condensation and quickly dis-
sipating dew if produced.
• Dew may be produced depending on the
conditions of
winds, and rain, and it may take time to
dehumidify.
• Never seal the surfaces of the dehumidi-
fying device.
Dehumidifying
device
Turn the circuit breaker off which supplies
the camera with the power when abnormal
conditions are encountered.
8
Bright subject
temperature, humidity,
Observe the following for installation.
• This apparatus is designed to be
installed under eaves. Install this appara-
tus under eaves to avoid direct sunlight.
• If this apparatus is installed outdoors
without eaves, ensure the same circum-
stances as being under eaves.
Avoid installing in the following locations.
• Locations where a chemical agent is
used such as a swimming pool
• Locations subject to steam and oil smoke
such as a kitchen
• Locations near flammable gas or vapor
• Locations where radiation or x-ray emis-
sions are produced
• Locations subject to strong magnetic
field or radio waves
• Locations where corrosive gas is pro-
duced
• Locations where it may be damaged by
briny air such as seashores
• Locations where the temperature is not
within –10 °C to +50 °C {14 °F to 122 °F}.
• Locations subject to vibrations (This
product is not designed for on-vehicle
use.)
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your partic-
ular environment.
Make sure that the installation area is strong
enough to hold the camera, such as a con-
crete ceiling.
When the installation area is not strong
enough, reinforce and strengthen it or use
Mounting Bracket (WV-CW484F, WV-CW
484FK: option, WV-CW484S, WV-CW484SK:
provided) or Ceiling Mount Bracket. (Refer to
p. 48 Optional Accessories.)
Do not install the camera in a humid or
dust-laden environment.
Otherwise, lifetime of the internal parts may
be shortened.