Preparation For Use - Bahco BE210 Manual

3. Preparation for use

When using the device for the first time, it is
important to insert the SD card as shown in the
following picture:
Connect the insertion tube to the display unit
as shown in the figure and tighten the locking
collar:
Press the POWER button during 3-5 seconds
to turn the display unit on. The Start-up screen
is shown briefly, followed by the status screen
during five seconds.
The status screen shows the capacity of the SD card and the internal battery. If the Video
Scope has been stored for a long time, it is possible that the internal batteries have been
fully discharged, and then the display might not turn on. Use the power adapter to recharge
the batteries.
English
27
Fig.1
Fig.2
Fig.3