Table of Contents
Advertisement
3
Remove the adjustment cover, and then adjust the angle of the camera lens.
Screwdriver
Adjustment
cover
* Be sure to install the adjustment cover after adjusting the angle of the camera lens.
Standard installation height and filming range
Adjust the angle of the camera lens when carrying out installation.
•
Vertical direction (facing the front)
(16° upward)
Note:
• The measurements and angles are for reference purposes and may vary depending
on the environment.
• If a strong light is against the door station, the visitor's face may not be
distinguishable. Do not place the door station in the following locations.
– Where most of the background is the sky.
– Where the background is a white wall, and direct sunlight will reflect off it.
– Where direct sunlight will shine on the door station.
– Depending on where this unit is installed, surrounding noises will cause howling
(beeping sound) to occur. Please avoid installing the unit in such a place.
• Make sure the back of the door station is not subject to water.
Wire type and distance
• Wire (between the monitor station and the door station):
Type: General cable CAT-3 24 AWG.
Distance: Maximum 100 m (about 328 feet).
Introduction and Installation
Angle adjustment lever
Left direction
(maximum 16°)
Upward direction
(maximum 16°)
•
Horizontal direction (facing the front)
(16° to the right)
•The angle can also be adjusted
16° to the left.
Right direction
(maximum 16°)
9
Advertisement
Table of Contents
