Advertisement
• After 160 hours of usage, the symbol
flashes for 30 seconds. The
grease filter must be cleaned and
charcoal filter must be replaced or
cleaned.
Refer to cleaning the grease
filter in care and cleaning
chapter.
4. CARE AND CLEANING
4.1 Notes on cleaning
Cleaning
Agents
Keep the hood
clean
Charcoal filter
4.2 Cleaning mode
Cleaning mode blocks the functionality of
control panel for 5 minutes. When active,
touching symbols has no effect.
Hob2Hood function is
disabled when cleaning
mode is active.
1. To activate the mode touch and hold
and
and
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water
and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains ap‐
pliance must be cooled down and dried with clean cloth or paper tow‐
els.
Clean stains with a mild detergent.
Clean the appliance and grease filters each month. Clean the interior
and grease filters carefully from fat. Fat accumulation or other residue
may cause fire.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle.
The grease filter may discolour, it has no influence on the performance
of the appliance.
The time of saturation of the charcoal filter varies depending on the
type of cooking and the regularity of cleaning the grease filter.
for 1 second.
turns on.
Refer to cleaning the
charcoal filter or replacing
the charcoal filter in care and
cleaning chapter.
To reset the function touch
seconds.
2. To deactivate the mode touch and
hold the symbols again for 1 second.
and
turns off.
4.3 Cleaning the grease filter
Filters are mounted with the use of clips
and pins on the opposite side.
To clean the filter:
1. Pull the handle on the filter
underneath the hood (1) and slightly
tilt the front of the filter down.
ENGLISH
5
for 3
Advertisement
