Rear Panel (Main Terminals); Power Cord; Speaker Leads - Pioneer DMH-ZF8550BT Quick Start Manual

[Power OFF] mode is cancelled, the control
signal is output again and the aerial is
extended with the auto aerial function (if
the aerial is being used). Be careful so that
the extended aerial does not come into
contact with any obstacles.
Rear panel
(main terminals)
This product
GPS aerial 3.55 m
iDatalink™ adaptor input
Refer to the instruction manual for the
iDatalink adaptor (Sold Separately.
Available in Australia and New Zealand).
USB port
Microphone 3 m
Aerial jack
Pre out supply
Power supply
Fuse (10A)
Wired remote input
Connect to steering wheel control
interface of your vehicle. For more
details, consult your dealer.
NOTES
• Before using and/or connecting the
iDatalink Maestro™ adaptor (Sold
Separately. Available in Australia and
New Zealand), you will need to first flash
the Maestro module with the appropriate
vehicle and head unit firmware. You can
find the device number that is required
for the activation on the followings (refer
to the Operation Manual.):
– The label on the packaging of this
product
– The label on this product
– The [Firmware Information] screen
• When the iDatalink Maestro adaptor is
connected, use the microphone of this
unit to perform voice operations for
Apple CarPlay or Android Auto™.
• Android Auto is a trademark of Google
LLC.
• Apple CarPlay is a trademark of Apple
Inc.
• iDatalink, Maestro and iData are
trademarks of Automotive Data Solutions
Inc., registered in the U.S. and other
countries.

Power cord

WARNING
IMPROPER CONNECTION MAY RESULT IN
SERIOUS DAMAGE OR INJURY
INCLUDING ELECTRICAL SHOCK, AND
INTERFERENCE WITH THE OPERATION
OF THE VEHICLE'S ANTILOCK BRAKING
SYSTEM, AUTOMATIC TRANSMISSION
AND SPEEDOMETER INDICATION.
To power supply
Power cord
Yellow
To terminal supplied with power
regardless of ignition switch position.
Red
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Violet/white
Of the two lead wires connected to the
back lamp, connect the one in which
the voltage changes when the gear shift
is in the REVERSE (R) position. This
connection enables the unit to sense
whether the car is moving forwards or
backwards.
Pink
Car speed signal input
Blue/white
Connect to system control terminal of
the power amp (max. 300 mA 12 V DC).
Light green
Used to detect the ON/OFF status of the
handbrake. This lead must be
connected to the power supply side of
the handbrake switch.
If this connection is made incorrectly
or omitted, certain functions of this
product will be unusable.
NOTE
The position of the speed detection circuit
and the position of the handbrake switch
vary depending on the vehicle model. For
details, consult your authorised Pioneer
dealer or an installation professional.

Speaker leads

Perform these connections when using a
subwoofer without the optional amplifier.
To power supply
Power cord
Left
Right
Front speaker (STD) or high range
speaker (NW)
Rear speaker (STD) or middle range
speaker (NW)
En
9