Table of Contents
Advertisement
13.5 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 30.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 30
Press Start / Reload.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
13.7 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press Start / Reload.
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press Start / Reload.
5.
13.8 Cancelling the pro-
gramme
Press Start / Reload.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 25
Remove the laundry.
3.
→ "Unloading the laundry",
Page 31
13.9 Unloading the laundry
Open the door.
1.
Remove the laundry from the
2.
drum.
13.10 Switching off the appli-
ance
Turn the programme selector to
1.
Turn off the tap.
2.
operation en
.
31
Advertisement
Table of Contents
