LG WT6105C Series Owner's Manual page 36

36 TROUBLESHOOTING
Problem
Rinse+Spin LED
Blinks
DRAIN FEATURE
Door Lock and
Control Lock LEDs
Blink
LID ERROR
Door Lock LED Blinks
LID LOCK ERROR
Extra Rinse and Cold
LEDs Blink
FOREIGN OBJECT
ERROR
Tub Clean LED Blinks
TUB CLEAN ALARM
Rinse+Spin and
Warm LEDs Blink
TEMPERATURE
SENSOR ERROR
Rinse+Spin and Cold
LEDs Blink
OVERFLOW ERROR
Hot LED Blinks
PRESSURE SENSOR
ERROR
Deep Fill and Cold
LEDs Blink
MOTOR LOCKED
ERROR
Deep Fill LED Blinks
CLUTCH ERROR
Deep Fill and Warm
LEDs Blink
SUPPLY VOLTAGE
ERROR
Special drain feature
• If the washer is paused during a cycle for more than 4 minutes, the cycle will be canceled
and any water remaining in the tub will be drained.
• This is not an error code. It indicates that the drain function is operating.
Lid is not closed properly.
• Close the lid properly.
• If the lid is closed and this error message is still displayed, call for service.
Lid is not locked properly.
• Make sure that the lid is closed properly and press the Start/Pause button. You can hear
the locking sound to lock the lid in the beginning of the cycle. The washer will not operate
unless the lid is locked.
• Make sure that nothing is caught under the lid, including shipping material or clothing.
• Make sure that the latch mechanism is fully retracted.Make sure that the latch mechanism
is fully retracted.
• If the lid is closed and this error message is still displayed, call for service.
Foreign objects such as coins, pins, clips, etc., are caught between the pulsator and the
inner tub.
• Turn the washer off then on again. Press the Spin button without selecting a cycle to drain
and spin the load.
• When the Spin cycle is completed, empty the tub and find and remove any objects caught
in the pulsator.
• Always check pockets, etc., before washing to prevent error codes or damage to the
washer or clothing.
It is time to run the Tub Clean cycle.
• This is not an error code. It indicates that the Tub Clean cycle is running or needs to be run
to clean the washer tub.
• Not applicable for all models.
Control error
• Unplug the washer and wait 60 minutes. Reconnect power and try again.
• If the error code is still displayed, call for service.
Water level is too high due to a faulty water valve.
• Close the water faucets, unplug the washer, and call for service.
The water level sensor is not working correctly.
• Close the water faucets, unplug the washer, and call for service.
A motor error has occurred.
• Allow the washer to stand for 30 minutes and then restart the cycle.
• If the error code is still displayed, call for service.
Clutch error
• Mechanical failure
• Unplug the washer and call for service.
Supply voltage is not correct.
• Please call LG service center. You can find your local LG service center phone number
onback cover page.
Possible Cause & Solution