Fault
timeLight does not
light up.
High spin speed not
reached.
The spin programme
does not start.
Rushing, hissing
noise.
Loud noises during
the spin cycle.
Cause and troubleshooting
timeLight deactivated in the basic settings.
→ "Overview of the basic settings", Page 37
▶
Energy-saving mode is active.
Press any button.
▶
a The symbol lights up again.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the
programme.
▶
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the
programme.
▶
Water is flushed under pressure into the detergent
drawer.
Not a fault – normal operating noise.
▶
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 21
▶
The appliance feet are not fixed.
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 21
Transit bolts have not been removed.
→ "Removing the transit bolts", Page 13.
▶
Troubleshooting en
49