Grip Adjustment; Viewfinder Adjustment; Shoulder Strap Attachment; Tripod Mounting - JVC GR-DVL149EG-X Instructions Manual

10
EN
Power Zoom Lever
Recording
Start/Stop
button
Power Switch
2
Downloaded from:
Dioptre
Adjustment Control
PAUSE
1
3
https://www.usersmanualguide.com/
GETTING STARTED

Grip Adjustment

1
Separate the Velcro strip.
2
Pass your right hand through the loop and grasp
the grip.
3
Adjust your thumb and fingers through the grip, to
easily operate the Recording Start/Stop button and
Power Switch and Power Zoom Lever. Be sure to
fasten the Velcro strip to your preference.

Viewfinder Adjustment

1
Set the Power Switch to "
pressing down the Lock Button located on the switch.
2
Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.

Shoulder Strap Attachment

1
Make sure the battery pack is removed. Following
the illustration, thread the strap through the eyelet
then fold it back and thread it through the buckle
Repeat the procedure to attach the other end of the
strap to the other eyelet
Strap . Confirm the strap is not twisted.

Tripod Mounting

CAUTION
When attaching the camcorder to a tripod, extend its
legs to stabilise the camcorder. It is not advised to
use small sized tripods. This may cause damage to
the unit by falling over.
1
To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and
stud hole on the camcorder. Then tighten the screw
clockwise. Some tripods are not equipped with studs.
(cont.)
" or " " while
3
located under the Grip
1
,
2
.