Pioneer VSX-935 Instruction Manual page 125

Hardware
‰ Auto Standby in HDMI Standby Through (Default Value: On)
Enable or disable "Auto Standby" while "HDMI Standby Through" is on.
On The setting will be enabled.
• This setting cannot be set to "On" if "Auto Standby" and
"HDMI Standby Through" are set to "Off".
Off
The setting will be disabled.
‰ USB Power Out at Standby (Default Value: Off)
Devices connected to the USB port (5 V/1 A) on the rear of the unit can be
supplied with electricity even when this unit is in standby mode when this
function is "On".
• Supply of power to USB devices in the standby mode is not supported for the
USB port on the front panel.
• When this function is set to "On", the power consumption in standby state
increases, however, the increase in power consumption is minimized
by automatically entering the HYBRID STANDBY mode where only the
essential circuits operate.
‰ Network Standby (Default Value: On)
When this function is set to "On", the network function works even in standby
state, and you can turn on the power of the unit via network using an
application such as Pioneer Remote App that can control this unit.
• When this function is set to "On", the power consumption in standby state
increases, however, the increase in power consumption is minimized
by automatically entering the HYBRID STANDBY mode where only the
essential circuits operate.
Note that even if this function is set to "Off", when any of the HDMI CEC
( →p123), HDMI Standby Through ( →p123), USB Power Out at Standby
( →p125) and Bluetooth Wakeup ( →p125) functions is enabled, this
function will be in "On" state regardless of the setting.
• When connection to the network is lost, "Network Standby" may be disabled
to reduce power consumption. In such a case, turn the unit on by using the
power button on the remote controller or main unit.
‰ Bluetooth Wakeup (Default Value: Off)
This function wakes up the unit on standby by connecting a BLUETOOTH
enabled device.
On When this function is used
• When this function is set to "On", the power consumption
in standby state increases, however, the increase in power
consumption is minimized by automatically entering the
HYBRID STANDBY mode where only the essential circuits
operate.
Off
When this function is not used
• This setting is fixed to "Off" if "Network/Bluetooth" -
"Bluetooth" - "Bluetooth Receiver" is set to "Off".
• This setting is also fixed to "Off" if "Network/Bluetooth" -
"Bluetooth" - "Bluetooth Receiver" - "Auto Input Change" is
set to "Off".
• Wait for a while if "Network Standby" and "Bluetooth Wakeup" cannot be
selected. It can be selected when the network function is activated.
Setup
125