Vfo Frequency Linkage; Wide/Narrow Band; Cross Band Repeat; Lcd Backlight - Qixiang Electron Science & Technology T4K-5888UV User Manual

7
General Setting

VFo FRequencY linkAGe

Enable this function, the adjustment any band of VFO frequency,
will bring same frequency change to both bands. Adjust one gear, the
frequency for both band will increase or decrease one step size value.
11
Press key to enter function menu.
21 Turn the Main band selector knob to
choose No42 menu. The LCD displays "VFOTR"
31 Press the Main band selector knob to enter function setup.
41
Switch the Main band selector knob to choose wanted value.
Available Values: ON, OFF.
51 Press the Main band selector knob or
key to store value and back to function menu. Press
or hold selector knob for over 0.5 second to store setup and exit.
This function only valid when both bands work on VFO mode.
28
NOTE

wide/nARRow bAnd

11
Press key to enter function menu.
21 Turn the Main band selector knob to
choose No43 menu. The LCD displays "WINNAR"
31 Press the Main band selector knob to enter function setup.
41
Switch the Main band selector knob to choose wanted value.
WIdE: Wide band (25KHz)
MIddLE: Middle band (20KHz)
NARROW: Narrow band (12.5KHz)
51
Press the Main band selector knob or
key to store value and back to
function menu. Press
selector knob for over 0.5 second to store setup and exit.
5888UV
key or hold

cRoSS bAnd RepeAt

Set the left band and right band as VHF (136~174MHz) and
UHF(400~470MHz)then turn of this function will enable Cross Band
repeater function.
11
Press key to enter function menu.
21
Switch the selector knob to choose No 44
function. The LCD displays "X-RPT"
31 Press the Main band selector knob, the
LCD displays "XSTART".
41 Press the Main band selector knob, the radio prompt "DU" and the
LCD displays "RPT", the corss band repeat function is on.
key
Press will turn off cross band function.
NOTE

lcd bAckliGht

11
Press key to enter function menu.
21 Turn the Main band selector knob to choose No. 45-47 menu. The
LCD displays "COL REd","COL GRN","COL BLU"
31 Press the Main band selector knob to
enter function setup.
41 Switch the Main band selector knob to
choose wanted value.Each color (Red,
blue, Green) with 32 brightness levels.
51 Press the Main band selector knob or
key to store value and back to
function menu. Press
selector knob for over 0.5 second to store
setup and exit.
key or hold