Beko B5WF U78415 WB User Manual page 11

4.1.4 Connecting to water supply
Models with a single water inlet shall not be connected to the hot water tap. In such a case the
laundry will get damaged or the product will switch to protection mode and will not operate.
WARNING
Do not use old or used water inlet hoses on a new product. It may cause water leakage from your
machine and stain your laundry.
1 Tighten all hose nuts by hand Never use a tool when tightening the nuts.
2 Open the taps completely after making the hose connection to check for water leaks at the
connection
points. If any leak occurs, turn off the tap and remove the nut. Check the gasket and tighten
the nut carefully again. In order to prevent the water leaks and resultant damages, keep the
taps closed when you do not use the product.
4.1.5 Connecting the drain hose to the drain
• Attach the end of the drain hose directly to waste water drain, washbasin or bathtub.
A
Your house will be flooded if the drain hose is dislocated during water draining. There is also a risk of burning due
to the high washing temperatures! In order to prevent such situations and make sure that the product performs
water intake and drain processes without any problem, fix the drain hose securely.
• Connect the drain hose to a minimum height of 40 cm and a maximum height of 100 cm.
• In case the drain hose is elevated after laying it on the floor level or close to the ground (less
than 40 cm above the ground), water draining becomes more difficult and the laundry may
come out excessively wet. Thus, follow the heights provided in the figure.
• To prevent the waste water to go back into the product again and to ensure easy drainage, do not
immerse the end of the hose into the waste water or do not insert it into the drain for more than
15 cm. If it is too long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose must not be
pinched between the drain and the product. Otherwise, water discharge issues may emerge.
• If the length of the hose is too short, use it by adding an original extension hose. The length of the
hose shall not be longer than 3.2 m. To prevent water leaks, always secure the connection
between the extension hose and the drain hose of the product with a suitable clamp so that it
does not come off and cause leaks.
Washing Machine / User's Manual
11 / EN