Beko B5WF U78415 WB User Manual page 10

4.1 Installation
A
Please read the "Safety Instructions" section first!
• Apply to the nearest authorized service agent for the installation of your product.
• Preparation of the location and electrical, tap water and waste water installations at
the place of installation is under customer's responsibility.
• Make sure that the water inlet and discharge hoses as well as the power cable are not
folded, pinched or crushed while pushing the product into its place after installation or
cleaning procedures.
• Make sure that the installation and electrical connections of the product are
performed by authorized service agent. Manufacturer shall not be held responsible for
damages caused by operations performed by unauthorized persons.
• Prior to installation, visually check if the product has any defects on it. Do not have it
installed if the appliance is damaged. Damaged products cause risks for your safety.
4.1.1 Appropriate installation location
• Place the product on a solid and level floor. Do not place it onto a carpet with high
pile or other similar surfaces. Inappropriate floor may cause problems of noise and
vibration.
• Total weight of the washing machine and the dryer -with full load- when they are
placed on top of each other reaches to approx. 180 kilograms. Place the product on
a solid and flat floor that has sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where temperature may fall below 0ºC. Freezing
might damage your product.
• Leave a minimum space of 1 cm between the product and the furniture.
• If you will install the product on a surface with steps, never place it close to the edge.
• Do not place the product on any platform.
• Do not place heat sources such as Hobs, Irons, Ovens, etc. on the washing machine
and do not use them on the product.
4.1.3 Removing transportation safety bolts
1 Loosen all transportation safety bolts with an appropriate wrench until they turn freely.
2 Remove transportation safety bolts by turning them gently.
3 Attach the plastic covers supplied in the User Manual bag into the holes on the rear
panel.
Remove the transportation safety bolts before operating the product! Otherwise, the product will get damaged.
Keep the transportation safety bolts in a safe place to reuse when the product needs to be moved again in the future.
WARNING
Install the transportation safety bolts in reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!
10 / EN
Washing Machine / User's Manual