Sangean SIR-300 Manual page 88

Set up UPnP access on a Windows PC - cont.
4. Rotate the Tuning Control Rotary until 'Shared media' is highlighted
and press the Tuning Control Rotary. The radio will scan for all
available UPnP servers. It may take a few seconds for the radio
to complete its scan. The radio will display '<Empty>' if no UPnP
servers are found.
5. After scanning, select your UPnP server using the Tuning Control
Rotary. If you are using WMP 11 as the server, your radio will then
normally display 'Unauthorized - Select to retry' at this stage.
6. Your PC may prompt you that there has been a connection to your
UPnP server. Whether prompted or not, in order that the radio may
access the music files, you will need to click the 'Library' tab in WMP
11 and select the 'Media Sharing...' item to open the 'Media Sharing'
window. Make sure the box 'Share my media to:' is ticked.
7. In the 'Media Sharing' window, the radio will be listed as an unknown
device. Click on the unknown device shown to select it, then click the
'Allow' button and then click 'OK'.
Note:
If you are using Microsoft Windows' firewall software, this should be
correctly configured by WMP 11. If you are using third party firewall
software you may need to manually configure it to allow your unit and
WMP 11 to communicate.
8. On the radio, select the named server again using the Tuning
Control Rotary. If WMP 11 is now able to communicate with your
87
radio you will be presented with some media selection options on the
display.