Table of Contents
Advertisement
en Troubleshooting
Fault
The water is not draining.
Water is not flowing in. De-
tergent is not being dis-
pensed.
The spin cycle runs several
times.
The programme duration
changes during the wash
cycle.
No water is visible in the
drum.
Drum jerks after the pro-
gramme starts.
46
Cause
The water outlet hose is con-
nected too high.
Pump cover is not correctly
assembled.
You have not pressed
Dodaj pranie.
The filters in the water inflow
are blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
The programme operation is
optimised electronically.
This may change the pro-
gramme duration.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
Water is below the visible
area.
This is caused by an internal
motor test.
troubleshooting
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 34
Install the water outlet hose at a
▶
maximum height of 1 metre.
→ "Technical specifications",
Page 54
Correctly assemble the pump
▶
cover.
→ "Cleaning the drain pump",
Page 39
Press
Dodaj pranie.
▶
Clean the filters in the water inflow
▶
→ Page 41.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Advertisement
Table of Contents
