Vent Control
The vent control is located above the control knobs. The operation method and the shape may vary in different models (see the following
figures)
For maximum cooling efficiency, CLOSE the vent. It will allow internal air circulation. OPEN the vent to discharge stale air.
CLOSE
NOTE: The vent control is not available for all the units. Some units do not have vent control.
OPERATING INSTRUCTIONS
NOTE: Different models have different operation panels. Not all the functions describing below are available for the air conditioner
you purchased. Please check the operation panel of the unit you purchased. The following graphics are
The actual shape shall prevail.
NOTE: Some models without MED fan speed feature and (or)
AUTO mode feature and (or) swing feature.
POWER:
Press the POWER keypad to turn the unit on/off.
MODE:
Press the "MODE" keypad to select the appropriate operating
mode. The mode selection will alternate between AUTO, HEAT
(cooling only models without), COOL, FAN and DRY.The indica-
tor light beside the "MODE" option will illuminate, identifying
the mode selected.
NOTE:Press the "MODE" keypad to select the FAN mode, you
can press "FAN" keypad to select your desired fan speed but
you can not adjust temperature.
TEMPERATURE SETTINGS UP:
Press the
keypad to increase the set (operating) temperature
of the unit. Each time the keypad is pressed the temperature
increases as follows:
1℃
(Celsius Scale) Maximum Setting
TEMPERATURE SETTINGS DOWN:
Press the
keypad to decrease the set (operating) temperature
of the unit. Each time the keypad is pressed the temperature
decreases as follows:
1℃
(Celsius Scale) Minimum Setting
FAN:
Press this keypad to activate the appropriate fan speed setting. Each depression of the keypad will alternate through LOW, MED(on some models),
HIGH fan speed options. The indicator light beside the FAN speed option will illuminate, identifying the fan speed selected.
SWING: (on some models)
Press the "SWING" keypad to activate the automatic air swing feature. The indicator light adjacent to the "SWING" keypad will illuminate, identifying
to the selected mode is operational. The vertical louvers will oscillate back and forth (side to side) automatically sweeping air alternately for comfortable
cooling/heating. To stop the air swing feature, press the "SWING" keypad again, the indicator light adjacent to the keypad will go off.
Wireless Operation: (on some models)
For the first time to use Wifi function, press the SWING button for 3 seconds to initiate the Wifi connection mode. The LED DISPLAY shows 'AP' to
indicate you can set Wifi connection. If connection(router) is successful within 8 minutes, the unit will exit Wifi connection mode automatically and the
Wireless indicator illuminates. If connection is failure within 8 minutes, the unit exits Wifi connection mode automatically.
TIMER:
(on some
models)
When the unit is on, press the Timer button will initiate the Auto stop program, the TIMER OFF indicator light illuminates. Press the UP or down button
•
to select the desired time. Press the TI MER button again within 10 seconds, the Auto start program is initiated. And the TI MER ON indicator light
illuminates. Press the up or down button to select the desired Auto start time.
•
When the unit is off, press the Timer button to initiate the Auto start program, press it again within 10 seconds will initiate the Auto stop program.
•
Press or hold the UP or DOWN button to change the Auto time by 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours.
The control will count down the time remaining until start.
•
The system will automatically revert back to display the previous temperature setting if there is no operation in a 10 seconds period.
•
Turning the unit ON or OFF at any time or adjusting the timer setting to 0.0 will cancel the Auto Start/Stop timer program.
TIMER:
(on some
models)
Press the "TIMER" keypad to activate the "auto start/auto stop" timer function.
Auto start/stop programs can be set from 0~12 hours. Each depression of the "TIMER" keypad will incrase the selected time in 1 hour increments.
DRY: (on some models)
This mode is used to decrease the humidity in the room. Under this mode, you cannot select a fan speed. The fan motor operates at LOW speed. Keep
windows and doors closed for the best dehumidifying effect.
COOL :
The temperature setting are adjustable between 17℃/16℃ to 30℃/31℃. You can select your desired fan speed.
HEAT: (on some models)
The temperature settings are adjustable between 17℃/16℃ to 30℃/31℃in heating mode. You can select your desired fan speed.
AUTO:
The fan motor remains on MED speed in AUTO mode. The unit will select the appropriate operating mode from FAN, COOL or HEAT(For reverse cycle
models only) based upon the temperature difference between the actual and desired room temperature.Some models wihtout MED speed,the fan motor
operates on HIGH speed in AUTO mode.
VENT
OPEN
30℃/31℃.
17℃/16℃.
CLOSE
12
OPEN
for explanatory purposes.