Table of Contents
Advertisement
en Installation and connection
ATTENTION!
¡ If the appliance is installed in
areas exposed to frost or out-
doors, frozen residual water may
damage the appliance and frozen
hoses may crack or split.
Do not install or operate this ap-
▶
pliance anywhere that is liable to
experience frost and/or out-
doors.
¡ The appliance underwent a func-
tion test before leaving the factory
and may, therefore, contain resid-
ual water. This residual water may
leak out if the appliance is tilted at
an angle greater than 40°.
Tilt the appliance carefully.
▶
Installation location Requirements
On a base
On a wooden joist
floor
In a kitchen unit
14
Secure the appliance
with fixing brackets
→ Page 26.
Place the appliance
on a water-resistant
wooden board which
is screwed tightly to
the floor. The wooden
board should be at
least 30 mm thick.
¡ A niche width of
60 cm is required.
¡ Only install the ap-
pliance under-
neath a continuous
worktop that is se-
curely connected
to adjacent cabin-
ets.
Installation location Requirements
On a wall
Removing the transit bolts
The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Notes
¡ Please read the safety information
→ Page 4 to ensure that you use
the appliance safely.
¡ Keep the transit bolts, screws and
sleeves in a safe place for future
transport → Page 49.
Pull the hoses out of the holders.
1.
Unscrew
and remove
2.
screws for the transit bolts with a
WAF 13 wrench.
Do not trap the hoses
between the wall and
the appliance.
all four
Advertisement
Table of Contents
