LG 86UR9000PUA Owner's Manual

Hide thumbs Also See for 86UR9000PUA:

Owner's manual (17 pages)

Table Of Contents

Table of Contents

Quick Links

LED TV*

OWNER'S MANUAL

Safety and Reference

* LG LED TV applies LCD screen with LED backlights.

Please read this manual carefully

before operating your set and retain it

for future reference.

43QNED75ARA

55QNED75URA

43QNED75URA

55QNED80ARA

50QNED75ARA

55QNED80URA

50QNED75URA

55QNED85ARA

50QNED80ARA

55QNED85URA

50QNED80URA

65QNED75ARA

55QNED75ARA

65QNED75URA

43UR8000AUA

50UR9000PUB

43UR8000AUB

55UR8000AUA

43UR9000PUA

55UR8000AUB

50UR8000AUA

55UR9000PUA

50UR8000AUB

65UR8000AUA

50UR9000PUA

65UR8000AUB

The model and serial number of the product are

located on the back and on one side of the product.

Record them below in case you ever need service.

Model

Serial No.

*MFL719464322301REV01*

65QNED80ARA

75QNED80URA

65QNED80URA

75QNED85ARA

65QNED85ARA

75QNED85URA

65QNED85URA

86QNED80ARA

75QNED75ARA

86QNED80URA

75QNED75URA

86QNED85ARA

75QNED80ARA

86QNED85URA

65UR9000PUA

75UR9000PUB

70UR8000AUA

86UR8000AUA

70UR8000AUB

86UR8000AUB

75UR8000AUA

86UR8000PUB

75UR8000AUB

86UR9000PUA

75UR9000PUA

www.lg.com

Printed in Korea

Supplier`s Declaration of

Conformity

Trade Name

Responsible

LG Electronics USA,

Party

Inc.

Address

111 Sylvan Avenue,

North Building,

Englewood Cliffs,

NJ 07632

E-mail

lg.environmental@

lge.com

LG Customer Information Center

For inquires or comments, visit www.

lg.com or call;

USA, Consumer

1-800-243-0000

User

USA, Commercial

1-888-865-3026

User

1-888-542-2623 CANADA

www.lg.com

Table of Contents

Summary of Contents for LG 86UR9000PUA

Page 1 Printed in Korea Safety and Reference Copyright © 2023 LG Electronics Inc. All Rights Reserved. * LG LED TV applies LCD screen with LED backlights. Please read this manual carefully before operating your set and retain it for future reference.
Page 2: Important Safety Instruction
By using this product, you agree that all disputes between you and LG arising out of or relating in any way to this product (including but not limited to warranty disputes) shall be resolved exclusively through binding arbitration on an individual basis. The terms of the arbitration agreement (including details on the procedure for resolving disputes) is available at www.lg.com/us/arbitration (USA) or www.lg.com/ca_en/arbitration (Canada).
Page 3 Warning! Safety instructions CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. The symbol is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Page 4: Installation
• Use only an authorized attachments / accessories approved by LG • Do not press strongly upon the panel with a hand or a sharp object such Electronics. Otherwise, this may result in fire, electric shock, malfunction, or product damage.
Page 5: Mounting To The Wall
We recommend that you use an LG brand wall mount. The LG wall mount is easy to adjust or to connect the cables. When you do not use LG’s wall mount bracket, use a wall mount bracket where the device is adequately secured to the wall with enough space to allow connectivity to external devices.
Page 6 Starting TV Turning on the TV Note • When the TV is turned on for the first time after being shipped from the You can simply operate the TV functions, using the button. factory, initialization of the TV may take approximately one minute. •...
Page 7 To obtain the RS-232C external control setup information, please visit www. • In order to control external devices through "Room to Room Share" and lg.com. Download and read the manual, (Depending upon model). "Hands-free Voice Control", an IR blaster connection is required.
Page 8: Specifications
Specifications Product specifications may be changed without prior notice due to upgrade of product functions. Estimated yearly energy consumption indicated on the FTC label is measured in accordance with the Test Procedures for Television Sets (USA only). The actual energy consumption depends on the usage environment (The content watched, TV settings, etc.). •...
Page 9: Product Information
Product Information (Only QNED85*, 86QNED80*, 86UR90*, 86UR80*) (Only QNED75*, 70/75UR80*) Wireless module(LGSBWAC95)Specifications Wireless module(LGSBWAC22)Specifications Wireless LAN (IEEE 802.11a/b/g/n/ac) Wireless LAN (IEEE 802.11a/b/g/n/ac) Frequency range Output Power (Max.) Frequency range Output Power (Max.) 2,400 to 2,483.5 MHz 18.5 dBm 2,400 to 2,483.5 MHz 17 dBm 5,150 to 5,725 MHz 18 dBm...
Page 10: Open Source Software Notice Information
LG Electronics will also provide open source code to you on CD-ROM for a charge covering the cost of performing such distribution (such as the cost of media, shipping, and handling) upon email request to opensource@lge.com.
Page 11: Troubleshooting
Troubleshooting In TV / HDMI input, press the button on the remote control three times to display the model name and serial number on the screen. Cannot control the TV with • Check if anything such as tape has been placed over the receiver. the remote control.
Page 12 Regulatory...
Page 13: Note To Cable/Tv Installer
If the existing television set is going to be retained and relocated, the same considerations as above should be applied. Symbols Refers to alternating current (AC). Refers to stand-by. Refers to direct current (DC). Refers to “ON” (power). Refers to class II equipment. Refers to dangerous voltage. LG Take-back & Recycling Policy...
Page 17: External Control Device Setup
OWNER’S MANUAL EXTERNAL CONTROL DEVICE SETUP Please read this manual carefully before operating the set and retain it for future reference. www.lg.com P/NO : MFL71445401 (1901-REV00)
Page 18: Key Codes
KEY CODES KEY CODES • This feature is not available for all models. Code Code Function Note Function Note (Hexa) (Hexa) CH +, PR + R/C Button List R/C Button CH -, PR - R/C Button Exit R/C Button Volume + R/C Button PIP(AD) R/C Button...
Page 19 (TV) (PC) • LGTV supports PL2303 chip-based (Vendor ID : 0x0557, Product ID : 0x2008) USB to serial(RS-232C) RS-232C IN converter which is not made nor provided by LG. (CONTROL & SERVICE) (PC) (TV) • It can be purchased from computer stores that carry accessories for IT support professionals.
Page 20 EXTERNAL CONTROL DEVICE SETUP (TV) (PC) (TV) (PC) Phone jack Type RS-232C IN • You need to purchase the phone-jack to RS-232 cable required for the connection between the PC and (CONTROL & SERVICE) (PC) (TV) the TV, which is specified in the manual. RS-232C IN (CONTROL &...
Page 21 EXTERNAL CONTROL DEVICE SETUP Communication Parameters • Baud rate : 9600 bps (UART) • Stop bit : 1 bit • Data length : 8 bits • Communication code : ASCII code • Parity : None • Use a crossed (reverse) cable. Command reference list (Depending on model) DATA...
Page 22 EXTERNAL CONTROL DEVICE SETUP Transmission / Receiving Protocol Transmission [Command1][Command2][ ][Set ID][ ][Data][Cr] [Command 1] : First command to control the TV. (j, k, m or x) [Command 2] : Second command to control the TV. [Set ID] : You can adjust the [Set ID] to choose desired monitor ID number in option menu. Adjustment range in TV is 1 to 99.
Page 23 EXTERNAL CONTROL DEVICE SETUP * Commands may work differently depending on model and signal. 01. Power (Command: k a) Ack [d][ ][Set ID][ ][OK/NG][Data][x] ► To control Power *On or Off of the set. * In case of video mute on only, TV will display On Transmission[k][a][ ][Set ID][ ][Data][Cr] Screen Display(OSD).
Page 24 EXTERNAL CONTROL DEVICE SETUP 08. Color/Colour (Command: k i) 13. Treble (Command: k r) ► To adjust the screen Color(Colour). ► To adjust treble. You can also adjust colour in the PICTURE menu. You can also adjust in the AUDIO menu. Transmission [k][i][ ][Set ID][ ][Data][Cr] Transmission [k][r][ ][Set ID][ ][Data][Cr] Data Min : 00 to Max : 64...
Page 25 EXTERNAL CONTROL DEVICE SETUP 18. Equalizer (Command : j v) * Analog Antenna/Cable ► Adjust EQ of the set. [Data 00][Data 01] Channel Data Transmission [j][v][ ][Set ID][ ][Data][Cr] Data 00 : High byte channel data Data 01 : Low byte channel data - 00 00 ~ 00 C7 (Decimal : 0 ~ 199) Data 02 : Input Source (Analog) - 00 : Antenna TV (ATV)
Page 26 EXTERNAL CONTROL DEVICE SETUP * Analog Antenna/Cable 2. Tune to the digital antenna (ATSC) channel 30-3. Set ID = All = 00 Data 00 : Physical Channel Number Data 00 = Don’t know Physical = 00 - Antenna (ATV) : 02~45 (Decimal: 2 ~ 69) Data 01 &...
Page 27 11 11 EXTERNAL CONTROL DEVICE SETUP 24. Input select (Command: x b) 2. Tune to the BS (ISDB-BS) channel 30. Set ID = All = 00 (Main Picture Input) Data 00 = Don’t know Physical = 00 ► To select input source for main picture. Data 01 &...
Page 28 EXTERNAL CONTROL DEVICE SETUP * [Data 02], [Data 03] functions depend on model 3) When [Data 00] is 06, 07 and signal. 00 : Off 01 : On * If [Data 00] is 00 (3D On), [Data 03] has no meaning.

LG 86UR9000PUA Owner's Manual

Quick Links

Related Manuals for LG 86UR9000PUA

Summary of Contents for LG 86UR9000PUA

This manual is also suitable for:

Table of Contents