Gigabyte Z790I AORUS ULTRA User Manual page 21

8) LED_C (RGB LED Strip Header)
The header can be used to connect a standard 5050 RGB LED strip (12V/G/R/B), with maximum power
rating of 2A (12V) and maximum length of 2m.
Connect one end of the RGB LED strip extension cable to the header and
the other end to your RGB LED strip. The black wire (marked with a triangle
on the plug) of the extension cable must be connected to Pin 1 (12V) of
this header. The 12V pin (marked with an arrow) on the other end of the
extension cable must be lined up with the 12V of the LED strip. Be careful
with the connection orientation of the LED strip; incorrect connection may
lead to the damage of the LED strip.
For how to turn on/off the lights of the LED strip, please navigate to the "Unique Features" page
of GIGABYTE's website.
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
9) SATA3 0/1 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
and RAID 1. Please navigate to the "Configuring a RAID Set" page of GIGABYTE's website for instructions
on configuring a RAID array.
To enable hot-plugging for the SATA ports, please visit the "BIOS Setup," "SATA And RST
Configuration," webpage of GIGABYTE's website for more information.
1
SATA3
1 0
1 7
7 1
- 21 -
Pin No. Definition
1 12V
2 G
3 R
4 B
RGB
LED
Strip
1
12V
DEBUG
PORT
Chipset supports RAID 0,
®
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND