Table of Contents
Advertisement
Installation
R When the batteries are fully charged, "Fully charged" is displayed.
Note:
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
charge again.
Removing the battery
Registering a handset to a base unit
1
Base unit:
Press and hold MLOCATORN for about 5 seconds.
R If all registered handsets start ringing, press MLOCATORN again to stop,
2
Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and
Note:
R If an error tone sounds, or if
the base unit's operating instructions.
6
2911_TGDA59C (en-en)_ver002.pdf 6
1
,
then repeat this step.
is displayed.
For assistance, visit www.panasonic.ca/english/support
4
3
2
1
) and the charge contacts with a dry cloth and
1
is displayed, register the handset according to
2
2
12/9/2016 8:02:02 AM
Advertisement
Table of Contents
