Advertisement
ASSEMBLY
1. Open the torso of the Prestan Professional Manikin by
popping the 'tabs' located on the shoulders of the Prestan
Professional Manikin and carefully lifting up the torso
frame. Do not lift by tabs. (Figure 1).
2. Attach the head to the torso by placing the neck of the head
onto the two spindles on the neck portion of the torso (Figure 2).
3. Fold the face shield lung bag:
•
The face shield lung bag has four 'dotted lines' printed on one side of the bag (along with an oval)
•
Using the four dotted lines, fold the face shield lung bag bellow into fourths, following the diagram below
Figure 3a
4. Tilt the head of the manikin (Figure 4).
5. Insert the lung bag, folded end, into the mouth
of the manikin (Figure 5).
6. Push the lung bag into the mouth until the bag exits
through the neck (Figure 6).
7. Grasp the lung bag and pull it through the neck (Figure 7).
8. The face shield lung bag is then placed on top of the
compression plate (the hard plastic piece found on top of
the torso foam core) with the oval printed on the face shield
lung bag matching the compression plate (Figure 8).
9. MAKE CERTAIN THAT THERE ARE NO TWISTS
IN THE LUNG BAG!
10. Attach the face shield tabs to the 'buttons' located on
the side of the manikin head (Figure 9).
11. The torso may then be closed by pushing down on the
shoulder tabs until they snap into place.
COPYRIGHT 2008 PRESTAN PRODUCTS LLC
Figure 3b
Figure 6
Figure 1
Figure 3c
Figure 4
Figure 8
Figure 2
Figure 3d
Figure 5
Figure 7
Figure 9
Rev. 03.15.11
Advertisement
