Polaris Scout 42 iQ Owner's Manual page 11

Polaris Robotic Pool Cleaner | Owner's Manual
®
Figure 15. Worn Brush Indicator
To maintain cleaner performance at its best, replace
the brushes as soon as one of the wear indicators
is reached (even if the wear is not even). It is
recommended that you replace the brushes when
the rubber is worn down to the top of the wear
indicator (or every two years, whichever comes first).
To replace a worn brush:
1. Stand the cleaner on its end in a vertical
position.
1
Figure 16. Cleaner in Upright Position
2. Separate the edges of the brush and undo the
tabs. Remove the worn brush.
Raised groove
becomes
partially flattened,
indicating
excessive wear.
Figure 17. Undo the Tabs of the Brush
3. Position the new brush underneath the roller
with the bristles facing downwards.
Figure 18. Position the New Brush on Roller
4. Thread each tab into the slot provided and
gently feed it through until the heel comes out at
the other side of the slot.
4
Figure 19. Pull Tabs Through Each Slot
5. Use a pair of scissors to cut the tabs 3/4 inch
from the heel so that they are no higher than the
cleaning blade.
ENGLISH
Page 11