Pioneer DMH-T450EX Installation Manual page 9

The adjusting position
and mounting
dimension of the
display
The mounting position of this product's
display can be adjusted. When mounting
the display, adjust the mounting position
so that your view is clear and it does not
impair your driving.
WARNING
Make sure that none of the following
conditions exist when mounting the
display. Otherwise, an accident may occur.
• It impairs the operation of the steering
wheel and levers (shift lever, windshield
wiper switch, turn signal switch, etc.).
• It impairs the operation of the airbags.
• It significantly impairs the operation of
the hazard switch.
• It impairs the ability to identify or operate
other control switches.
• You are unable to see gauges, meters or
warning indicators.
• It interferes with in-vehicle devices
(switches, panel, glove compartment, cup
holder, etc.).
Depending on the vehicle, the display may
hinder access to the glove compartment or
cup holder, or it may block the air
conditioner vents.
Display mounting dimensions
61 (2-3/8)
28.5 (1-1/8)
mm (in.)
Adjustable display angles and vertical positions
WARNING
Keep hands and fingers clear of this product when adjusting the display angle. Be especially
cautious of children's hands and fingers.
View from side
13˚ 13˚
5.5 (1/4)
13 (1/2)
20.5 (3/4)
View from above
13˚
13˚
▶Adjusting the angle of the display
Grab the display at each side and tilt it forward, backward, leftward or rightward.
▶Adjusting the vertical position of the display
Slide the display upward or downward while sliding the lever ( ) on both sides.
28 (1-1/8)
35.4 (1-3/8)
mm (in.)
En
9