Hisense RF210N6AHE Use & Care Manual page 9

Table of Contents

Advertisement

9. If necessary, use a hex-key wrench to remove
the two bolts fastening the bottom hinge to
the front of the cabinet, and then remove the
hinge.
10. Repeat this procedure to remove the other
door.
Remove the Front of the Freezer Drawer
1. Slide open the freezer drawer to its full
extension.
2. Slide open the upper storage drawer to its full
extension.
Remove the upper storage drawer from the
3.
glide rails by lifting up and pulling out at an
angle.
4.
Remove the lower storage compartment by
lifting upward at an angle.
Remove one fixing screw (left and right
5.
each) from the side of the slide rail.
a Screws
Grab the drawer door by using both
6.
hands and
pull it up to make sure
the door detaches from the front of the
slide rail and then move forward to
remove the freezer drawer door.
Set the drawer front on a soft surface to
7.
protect the fi nish.
8.
Slide the drawer glide rails into the cabinet.
Move the refrigerator through the doorway
9.
and into the room near the water and electrical
connections.
Replace the Doors
1. If removed, reinstall the bottom hinge.
2. Using two or more people, set the refrigerator
3. Insert the top hinge into the top of the door.
4. Using the three screws removed earlier, fasten
5. Repeat steps 1 through 4 to replace the
6. Using the three screws removed earlier, reinstall
IMPORTANT: The refrigerator must be located
on a solid, level surface that is strong enough to
support the refrigerator fully loaded.
a
Complete the Installation
1. Plug into a grounded 3 prong outlet.
2. Move the refrigerator into its final location,
door onto the bottom hinge.
the top hinge to the top of the cabinet.
NOTE: Left-hand door only, replace the ground
screw into the top hinge.
opposite door.
the top hinge cover and control panel to the
top of the cabinet.
Before moving, retract the leveling legs to
avoid scraping the floor.
The refrigerator has wheels, which should
be used for only forward and backward
movement.
NOTE: Trying to move the refrigerator sideways
may damage your floor.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the
power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death,
fire or electrical shock.
NOTE: This refrigerator begins operating as
soon as it is connected to the power supply.
making sure to maintain the recommended
clearance.
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rf210n6ase

Table of Contents