Watching Videos And Dvds; Displaying Pc Screen On Tv - Panasonic Viera TH-65PX600 Operating Instructions Manual

Watching Videos and DVDs

Some Panasonic equipment connected to the TV unit can be operated with the remote control.
Programming the remote control is necessary to operate other manufacturers' products. (p. 43)
With VCR or DVD turned On
1
Switch to external input
Press to display the Input select menu.
Select the input mode
2
Input select
[1] TV
[2] Component 1
[3] Component 2
[4] HDMI 1
[5] HDMI 2
- - [6] HDMI 3
[7] Video 1
[8] Video 2
[9] Video 3
[0] PC
•
The terminal and label of the connected device is
indicated.
To change the input label (p. 40)
3
Operate
the VCR or DVD with the remote control
Press to return to
TV
Note
•
For details, see the
manual of the
equipment
or ask your local
dealer.
(For other operations, see p. 46.)
26
Press corresponding NUMBER
key on the remote control to
select the input of your choice.
or
Press arrow up/down to select
select
the input of your choice, then
press OK.
•
enter
If during selection, no action
is taken for several seconds,
the "Input select" menu is
exited.
Label
(Initial screen)
Video 1
VCR
[example]
VCR MODE DVD MODE
VCR Record Record
- Open/Close
- Skip Reverse/Forward
Rewind/Fast Forward Reverse/Forward
Stop Stop
Pause Pause
Play Play

Displaying PC Screen on TV

The screen of the PC connected to the unit can be displayed on the TV.
You can also listen to PC sound with the audio cable connected. To connect PC (p. 44)
PC menu setting
•
Making settings
Menu Item
Terminal
(example)
PC
adjust
•
Audio menu (p. 28)
•
For PC input, only audio signals can be output from PROG. OUT terminals.
Select the external input
1
Select "PC"
2
PC
To return to TV
(changed as desired)
"How to Use Menu Functions" to (p. 28)
Adjustments/Configurations(options)
Normal Resets PC adjust
•
H&V : The H and V sync signals are input from the HD/VD connector.
•
Sync On G : Uses a synchronized signal on the Video G signal, which is input from the G
connector.
Alleviates the problem if a picture appears to be vertically-striped, flickers partially or is
Dot clock
blurred.
Adjust the horizontal position.
H-position
Adjust the vertical position.
V-position
Alleviates the problem if the whole picture appears to flicker or is blurred.
First adjust the Dot Clock to get the best possible picture, then adjust the
Clock phase
Clock Phase so that a clear picture appears.
Note
It may not be possible to display a clear picture due to poor input signals.
Switches to wide display.
•
Input
Input signal switched from VGA to WVGA
resolution
•
Input signal switched from XGA to WXGA
Displays the H (Horizontal)/V (Vertical) frequencies.
•
Display range
H-frequency
V-frequency
Horizontal: 15 - 110kHz
Vertical: 48 - 120Hz
•
Corresponding signals
(p. 26)
Displays
PC screen
27