Advertisement
Stand
Base
Figure A.4
Power Cable
Cable
management
cover
Connect to Computer
Figure B.1
audio output
Power Button
Figure C.1
Non-abrasive surface
Figure R.1
Figure R.3
Replace screws
100 mm
Specifications
4-SCREWS (M4)
MAX depth: 8.5mm
If use other screw,
check length of screw.
Weight of LCD assembly: 6.0 kg (MAX) (LCD205WXM)
01_English
3. Remove the Cable management cover (Figure A.4).
4. Connect all cables to the appropriate connector on the back of the
Cable management cover
5. Connect one end of the power cord to the monitor and the other
Input (VGA)
6. To attach the Cable management cover, insert the tabs of the
Input (Audio)
Input (DVI)
NOTE:
NOTE:
Headphone
7. Turn on the monitor with the front power button and the computer
8. No-touch Auto Adjust automatically adjusts the monitor to optimal
NOTE:
Raise and Lower Monitor Screen
Figure RL.1
The monitor may be raised or lowered. To raise or lower screen, place
hands on each side of the monitor and lift or lower to the desired
height (Figure RL.1).
NOTE:
Tilt and Swivel
Grasp both sides of the monitor screen with your hands and adjust
the tilt and swivel as desired (Figure TS.1).
Figure R.2
NOTE:
Remove Monitor Stand for Mounting
To prepare the monitor for alternative mounting purposes:
1. Disconnect all cables.
2. Place monitor face down on a non-abrasive surface (Figure R.1).
3. Remove the 4 screws connecting the monitor to the stand and
Figure TS.1
4. Connect all cables to the back of the monitor (Figure R.3).
Thickness
of Bracket (Arm)
5. Reverse this process to re-attach stand.
2.0 ~ 3.2 mm
NOTE:
NOTE:
Tighten all
screws
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm.
100 mm
Please use the attached screws (4pcs) as shown in the picture when
installing. To meet the safety requirements, the monitor must be
mounted to an arm which guaranties the necessary stability under
consideration of the weight of the monitor. The LCD monitor shall only
be used with an approved arm (e.g. GS mark).
6.3 kg (MAX) (LCD225WXM)
English-2
2
monitor (Figure B.1). Connect Headphones
(not included) to the appropriate connector at the rear side of the
monitor, if desired (Figure B.1).
end to the power outlet. Position the Video Signal Cable, Audio
cable and power cord between the holes on the Stand.
Cable management cover into the holes on the Stand and slide
the Cable management cover downward into place (Figure B.1)
making sure that the tabs are completely secure.
Adjust the position of the cables that are placed under the
Cable management cover to avoid damaging the cable or
monitor.
Please refer to the Caution section of this manual for proper
selection of power cord.
(Figure C.1).
settings upon initial setup for most timings (Analog input only).
For further adjustments, use the following OSD controls:
•
Auto Contrast
•
Auto Adjust
Refer to the Controls section of this User's Manual for a full
description of these OSD controls.
If you have any problem, please refer to the
Troubleshooting section (CD-ROM).
Handle with care when raising or lowering the monitor
screen.
Handle with care when tilting and swivelling the monitor screen.
remove the stand as indicated (Figure R.2). The monitor is now
ready for mounting in an alternative manner.
Use only VESA-compatible alternative mounting method.
Handle with care when removing monitor stand.
6/6/07, 8:36 AM
Advertisement
