Mounting The Gps200 To A Standard Marine Pole Mount; Connecting The Gps200; Figure 2 - Mounting The Gps200 To A Standard Marine Pole Mount - Maretron GPS200-01 User Manual

2.3.2 Mounting the GPS200 to a Standard Marine Pole Mount

Screw the included GPS200 antenna mount base to the standard marine mount. Thread the
®
NMEA 2000 cable through the standard marine mount and the antenna mount base from the
bottom out through the top and connect it to the GPS200 unit (see Section 2.4 below). Finally,
attach the GPS200 to the antenna mount base using the included brass mounting screws and
lock washers as shown in Figure 2. Do not use threadlocking compounds containing
methacrylate ester, such as Loctite Red (271), as they will cause stress cracking of the plastic
enclosure.
Figure 2 – Mounting the GPS200 to a Standard Marine Pole Mount

2.4 Connecting the GPS200

®
The Maretron GPS200 provides a connection to an NMEA 2000 interface through a connector
that can be found on the bottom of the device (see Figure 3).
Revision 1.3 Page 3