Installation Instructions; Before Using Your Appliance; Installation Of Your Appliance; Built-In Cabinet Instructions - Avanti WCD52SZ3S Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

Ø BEFORE USING YOUR APPLIANCE
·
Remove the exterior and interior packing.
·
Check to be sure you have all of the following parts:
1
Instruction Manual
1 Set
Door Swing Reversal Hinges
1 – Upper Stainless Steel Hinge
1 – Lower Stainless Steel Hinge
2
Hinge Screw Caps
1 Set
Stainless Steel Handle Assembly
1 – Stainless Steel Handle
2 – Handle Mounting Screws (Pre-installed on door)
·
Before connecting this appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
· Clean the interior surface with lukewarm water using a soft cloth.
Ø INSTALLATION OF YOUR APPLIANCE
·
This appliance is designed to be for free standing installation or built-in (fully recessed).
·
Place your appliance on a floor that is strong enough to support it when it is fully loaded. To
level your appliance, adjust the front leveling legs at the bottom of the appliance.
·
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
·
Avoid locating the unit in moist areas.
·
Plug the appliance into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
Ø
BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both built-in or free standing installation. If you plan to use this unit in a built-
in application please follow the requirements shown to the right.
INSTALLATION DIMENSIONS
Unit Dimensions
Inches
Height
33.5 – 34
Width
23.5
Depth
21-22.75
Cabinet Opening Dimensions
Inches
Height
34.75
Width
24
Depth
24.25

INSTALLATION INSTRUCTIONS

MM
850 – 865
595
533-578
MM
880
605
613
9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WCD52SZ3S and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Wcd46dz3sBcd50z3s

Table of Contents