Carrier PH4G-B Series Installation Instructions Manual page 34

PH4G--B: Installation Instruction
Start-Up Checklist
(Remove and Store in Job Files)
I. PRELIMINARY INFORMATION
MODEL NO.: ____________________________________________
SERIAL NO.: ____________________________________________
DATE: __________________________________________________
TECHNICIAN: ___________________________________________
II. PRESTART-UP (Insert check mark in box as each item is completed)
( ) VERIFY THAT ALL PACKING MATERIALS HAVE BEEN REMOVED FROM UNIT
( ) REMOVE ALL SHIPPING HOLD DOWN BOLTS AND BRACKETS PER INSTALLATION INSTRUCTIONS
( ) CHECK ALL ELECTRICAL CONNECTIONS AND TERMINALS FOR TIGHTNESS
( ) CHECK THAT INDOOR (EVAPORATOR) AIR FILTER IS CLEAN AND IN PLACE
( ) VERIFY THAT UNIT INSTALLATION IS LEVEL
( ) CHECK FAN WHEEL, AND PROPELLER FOR LOCATION IN HOUSING/ORIFICE AND SETSCREW TIGHTNESS
III. START-UP
ELECTRICAL
SUPPLY VOLTAGE _______________________________________
COMPRESSOR AMPS ____________________________________
INDOOR (EVAPORATOR) FAN AMPS _______________________
TEMPERATURES
OUTDOOR (CONDENSER) AIR TEMPERATURE __________ DB
RETURN-AIR TEMPERATURE__________ DB ___________ WB
COOLING SUPPLY AIR ________________ DB ___________ WB
HEAT PUMP SUPPLY AIR _________________________________
ELECTRICAL HEAT SUPPLY AIR __________________________
PRESSURES
REFRIGERANT SUCTION____________ PSIG,SUCTION LINE TEMP* ___________________
REFRIGERANT DISCHARGE ____________ PSIG, LIQUID TEMP† _______________________
( ) VERIFY REFRIGERANT CHARGE USING CHARGING CHARTS
* Measured at suction inlet to compressor
{Measured at liquid line leaving condenser.
Edition Date: 04/20
©2020 CAC/BDP• 7310 W. Morris Street • Indianapolis, IN 46231
Catalog No: IM-PH4G-07
Replaces: IM-PH4G-06
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
34