Table of Contents
Advertisement
NLSet up and connect
Remark:Observe the pumping
heights.
The pumping heights are: minimum
Washbasin
plastic stand
pipe with rubber
run muff
4.6 Adjusting the device
To reduce noise and vibrations and
avoid the device walking, set the
device horizontally.
Loosen the lock nuts with a SW17
1.
open-end wrench.
16
al: 100 cm
The connection position
tie with one
hose clamp
(24-40 mm) Bore
gene.
The water
feeding hose with
a bend
→ Page 28
fix and bor-
gene.
The water
feeding hose with
a bend
→ Page 28
fix and bor-
gene.
To adjust the device, turn the device
2.
feet. Check the horizontal
adjustment of the device with a
spirit level.
All device feet must be firmly on the
floor.
Tighten the counter nuts against
3.
the housing hand-tight with a
SW17 open-end wrench.
Hold the appliance foot firmly
and do not adjust the height.
4.7 Connecting the device
electrically
Remark:Your domestic electrical
installation for this appliance must
comply with local legal and safety
regulations and must include an
earth leakage circuit breaker.
Advertisement
Table of Contents
