Table of Contents
Advertisement
Malfunction
The program duration
changes during the wash
cycle.
The water is not
visible in the drum
bar.
Drum shakes
program start.
In the compartment
there is residual water.
Vibration and movement
of the appliance
during the centrifuge
run.
Drum turns, there
no water flows into
the device.
Cause and Troubleshooting
The program sequence is optimized electronically. This
may lead to changes in the program duration.
No error - no action required.
▶
The imbalance control system removes the imbalance
by distributing the laundry several times.
No error - no action required.
▶
Remark:When loading, if possible, place large and
small items of laundry together in the drum. Laundry
of different sizes is distributed better during the spin
cycle.
Foam control system performs an extra rinse in case
of excessive foam formation.
No error - no action required.
▶
The water is below the visible range.
No error - no action required.
▶
▶
Do not fill the appliance with additional water during
operation.
The cause is an internal engine test.
No error - no action required.
▶
Insert in compartment is clogged.
→ "Cleaning the detergent drawer", page
▶
35
The appliance is not leveled correctly.
→ "Adjusting the device", page 16
▶
Device feet are not fixed.
Secure the device feet.
▶
→ "Adjusting the device", page 16
Transport protection devices have not been removed.
→ "Remove transport protection", page 14 .
▶
Load recognition is active.
No error, no action required.
▶
Remark:The load recognition can take up to 2 minutes.
TroubleshootingNL
45
Advertisement
Table of Contents
