Table of Contents
Advertisement
NLSet up and connect
Transport the device upright.
▶
Place of installation
Holder
Floor with wooden
beams
Kitchenette
On a wall
14
Requirements
The device with
locking tabs
→ Page 29
to confirm.
Place the device
count on a
resistant
wooden plate (thick
too minimal
30mm) which
screwed firmly
to the floor.
The device al-
borrow under one
continuous work
place sheet,
that with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
Remark:If
the cover plate
will be removed,
must be the metal
cover plate
→ "Accessories",
Page 29 in front of
building it in
be confirmed
tid.
No mains connection
cable and none
snakes in between
wall and equipment
wedge in.
4.4 Remove transport
protection devices
The device is secured for transport
with transport locks on the back of the
device.
Remark:Keep the bolts of the
transport protection devices and the
sleeves for later transport.
→ "Install transport protection", page
49
Pull the hoses out of the holders.
1.
Loosen and remove all bolts of the 4
2.
transport protection devices with
an open-end wrench SW13
.
Advertisement
Table of Contents
