Panasonic HDC-HS80PU Service Manual page 39

Service Manual
Diagrams and Replacement
Parts List
High Definition Video Camera
Model No.
HDC-HS80P HDC-HS80GA
HDC-HS80PC HDC-HS80GC
HDC-HS80PU HDC-HS80GN
HDC-HS80EB HDC-HS80GT
HDC-HS80EC HDC-HS80GK
HDC-HS80EE
HDC-HS80EG
HDC-HS80EP
Vol. 1
Colour
(K)...........Black Type
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. SD P.C.B. .............................................................................. S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S4. Schematic Diagram .................................................................. S-4
S4.1. Interconnection Diagram ....................................................... S-4
S4.2. SD Schematic Diagram ......................................................... S-5
S5. Print Circuit Board .................................................................... S-6
S5.1. SD P.C.B. .............................................................................. S-6
S6. Replacement Parts List ............................................................ S-7
S7. Exploded View ....................................................................... S-11
S7.1. Frame and Casing Section.................................................. S-11
S7.2. Packing Parts and Accessories Section .............................. S-12
VM1102015CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as "
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
Name of Signal
S-1
HAVE THE SPECIAL CHARACTERISTICS
" mark.
Circuit name being connected.
This signal is connected
OFTR FEP
to the FEP schematic diagram.