Advertisement
fig .1
5 . OPeRATION
WARNING! ensure you read, understand and apply safety instructions before use .
NOTe : Only use impact sockets which are specifically designed for use with a impact wrench.
5 .1
Connect the wrench to the air hose as in section 3.
5 .2
Place the socket over the subject nut and depress the trigger to operate the wrench.
5 .3
To change direction push the button at the rear of the head assembly.
5 .4
The flow of air may be regulated by turning the same button.
DO NOT use any additional force upon the wrench in order to remove a nut.
DO NOT allow wrench to free run for an extended period as this will shorten its life.
6 . MAINTeNANCe
WARNING! Disconnect wrench from air supply before changing accessories, servicing or performing maintenance. replace or repair
damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
6 .1 .
If the air system does not have an oiler, lubricate the air wrench daily with a few drops of Sealey air tool oil dripped into the air inlet.
6 .2 .
Check and top up the gearbox by removing grub screw located under the impact head.
6 .3 .
Clean the wrench after use. DO NOT use worn, or damaged sockets.
6 .4 .
loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose connectors. To remedy check the
air supply and follow instructions in chapter 4.
b) Grit or gum deposits in the wrench may also reduce performance. If your model has an air strainer (located in the area of the air
inlet), remove the strainer and clean it. Flush the wrench out with gum solvent oil or an equal mixture of SAE No 10 oil and paraffin.
Allow to dry before use.
6 .5 .
For a full service contact your local Sealey service agent.
6 .6 .
When not in use, disconnect from air supply, clean wrench and store in a safe, dry, childproof location.
Parts support is available for this product . To obtain a parts listing and/or diagram,
please log on to www .sealey .co .uk, email sales@sealey .co .uk or telephone 01284 757500 .
Recycle unwanted materials instead of disposing of them as waste . All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment .
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations .
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTy: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INfORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey limited
environmental Protection
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7Ar
Original Language Version
fig .2
www.sealey.co.uk
01284 757500
sales@sealey.co.uk
01284 703534
SA602l
Issue: 2(SP) - 21/05/14
Advertisement
