Technical Information - HYPERICE Normatec 3 Instructions Manual

CLEANING THE SYSTEM
To clean the control unit:
• Wipe down the system with a damp, clean cloth.
• Dry thoroughly with a clean cloth.
Cleaning the single-person use leg, arm, or hip attachments:
• Wipe down the leg, arm, or hip attachments inside and out with a damp, clean cloth.
• Dry thoroughly with a clean cloth.
• Do not machine wash or dry.
• Do not dry clean.
MAINTAINING THE SYSTEM
The control unit, hose, charger, and attachments (leg, arm, or hip) require no routine
maintenance or service except for the care in this section.
STORING THE SYSTEM
Store control unit, hose, charger, and attachments (leg, arm, or hip) in a clean, dry location.
REPLACEMENT PARTS
Please call customer service at +1.949.565.4994 or visit our website at hyperice.com for
information regarding available replacement parts and accessories.

TECHNICAL INFORMATION

Do not attempt to take apart the system. The system has no user-serviceable parts. There are
no user-replaceable fuses.
BLUETOOTH WIRELESS TECHNOLOGY
The Bluetooth word mark and logos are owned by Bluetooth SIG, Inc., and any use of
such marks by Hyperice is under license. In the unlikely event of loss of a stable Bluetooth
connection, the system will attempt to re-establish its connection automatically. The Normatec
3 control unit is completely autonomous, and will continue operating normally, even during a
loss of connectivity. If this control unit does cause interference, which can be determined by
turning the control unit off and on, the user is encouraged to try to correct the interference by
reorienting or relocating the control unit, increasing the separation between equipment and the
control unit, or connecting the control unit to a different outlet on a circuit if it is plugged in.
The Normatec 3 control unit uses Bluetooth 5.0 wireless technology with the following radio
specifications:
Frequency
Modulations
Transmit Power
Receiver Sensitivity
Security
FCC ID: 2AY3Y-NT3
FCC ID: 2AY3Y-NT3A IC:23655-NT3A
See device label for details.
This control unit complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This control unit may not cause harmful interference, and (2) this control
unit must accept any interference received, including interference that may cause undesired
operation. This control unit complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this control unit may not cause
interference, and (2) this control unit must accept any interference, including interference that
may cause undesired operation of the control unit.
This equipment complies with FCC/ISED radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the
ISED radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that
are deemed to comply without testing of specific absorption rate (SAR).
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC ID: 2AY3Y-NT3
IC: 23655-NT3
IC:23655-NT3
FCC ID: 2AY3Y-NT3A
IC:23655-NT3A
2402 to 2480 MHz
GFSK
+4 dBm
-96 dBm (BLE mode)
AES HW