Toxic Materials; Maintenance - GE Baker Hughes Druck PV 411A Instruction Manual

Pneumatic/hydraulic hand-pump

Hide thumbs Also See for Baker Hughes Druck PV 411A:

Table of Contents

Introduction

This manual provides operating instructions for the PV 411A Pneumatic/Hydraulic hand-

pump compatible with the requirements of line operation. The PV 411A supersedes the

PV 411.

Safety

The manufacturer has designed this equipment to be safe when operated using the

procedures detailed in this manual. The user must not use this equipment for any other

purpose than that stated. Only use hydraulic fluids stated in the specification.

This manual contains safety and operating instructions that must be followed to make sure of

safe operation and to keep the equipment in a safe condition. The safety instructions are

either warnings or cautions issued to protect the user and the equipment from injury or

damage.

Users are to check that there is no visible gap or play between the plastic halves of the

PV 411A prior to use. If a visible gap or play is evident, do not use, contact your local Service

Center. See Section 6.2 on page 13 for more details.

Use suitably qualified technicians

manual.

Pressure

Do not apply pressure greater than the maximum safe working pressure stated in the

specification.

Toxic Materials

There are no known toxic materials used in construction of this equipment.

The equipment must be maintained using the procedures in this publication. Further

manufacturer's procedures should be done by an authorized service agents or the

manufacturer's service departments.

A qualified technician must have the necessary technical knowledge, documentation, special test

equipment and tools to carry out the required work on this equipment.

and good engineering practice for all procedures in this

PV 411A Instruction Manual-English | 1

Table of Contents