JVC KD-X282DBT Instruction Manual page 22

Bluetooth®
(for KD-X282DBT)
Pair and connect a Bluetooth device for the first time
Press B SRC to turn on the unit.
1
2 Search and select the name of your receiver ("KD-X282DBT") on the
Bluetooth device.
"BT PAIRING" flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal
Identification Number (PIN) code immediately after searching.
3
Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps
described below.
(A) "Device Name" "XXXXXX"
"XXXXXX" is a 6-digit passkey randomly generated during each
pairing.
Ensure that the passkeys appear on the unit and Bluetooth
device are the same.
Press the volume knob to confirm the passkey.
Operate the Bluetooth device to confirm the passkey.
(B) "Device Name" "VOL – YES"
Press the volume knob to start pairing.
• If "PAIRING" "PIN 0000" scrolls on the display, enter the PIN
code "0000" into the Bluetooth device.
You can change to a desired PIN code before pairing.
(Page 18)
• If only "PAIRING" appears, operate the Bluetooth device to
confirm pairing.
"PAIRING COMPLETED" appears when pairing is completed and "O" will light
up when the Bluetooth connection is established.
• " " and/or " " indicator(s) light(s) up.
14
ENGLISH
"VOL – YES" "BACK – NO"
"BACK – NO"
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device, see
[DEVICE DELETE] on page 18.
• A maximum of two Bluetooth phones and one Bluetooth audio device can
be connected at any time. To connect or disconnect the registered device,
see [PHONE SELECT] or [AUDIO SELECT] in [BT MODE]. (Page 18)
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. (Page 19)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• When the battery of the connected Bluetooth device runs low, "Device
Name" "LOW BATTERY" appears.
• Refer to the instruction manual of the Bluetooth device for more
information.