Advertisement
4. Wait for the red LED light to stop blinking and glow steadily
a. The web interface is available once the Green LED and Red LED are on simultaneously.
b. Quickly press the "IP/Reset" button and the device will announce the IP Address
Note: If the Red and Green LED do not light at the same time, your network did not assign the device an IP. Go back to
step 1.
c. Using a web browser navigate to the following:
XX.XX.XX.XX)
i. Click "Advanced"
ii. Click "Update"
iii. In the Administrator Login box enter: 0000
iv. Under Update Policy select "Update Automatically"
v. Under Setting URL enter the following:
vi. Click "Apply"
vii. Click "Reboot" and "Yes" This reboot process can take up to 5 minutes.
Note: Do NOT remove the device's power supply (Ethernet cable when using PoE, power adapter when not using PoE)
when the red light is on or blinking; a firmware update is ongoing. Cutting off the device's power during a firmware
update (red LED on, green LED off) will damage the firmware and render the PA1 inoperable. In such cases, it will need
to be returned to the vendor for resetting.
5. The web interface is available once the Green LED and Red LED are on simultaneously.
https://XX.XX.XX.XX
(Input device assigned IP Address for
http://pps.calltower.com/snom/settings/snomPA1.xml
https://www.uc.solutions/Additional_Solutions/SNOM-PA1/SNOM-PA1_-_Set-up
Updated: Mon, 13 Feb 2023 21:25:19 GMT
Powered by
2
Advertisement
