Advertisement
Quick Links
SNOM-PA1 - Set-up
Configuration
1. Ensure the network is configured with DHCP
2. Plug the Ethernet cable into the RJ45 connector labelled "Port 1PoE".
a. The second RJ45 connector labelled "Port 2" is for daisy-chaining further Ethernet devices without the need for
another Ethernet cable.
Note: If no PoE available: Connect a snom-approved 5 V 10 W power adapter to the power connector labelled "5V DC".
(Not included – must be ordered).
3. Plug a speaker device (speaker wire or audio jack labeled "line out") into the PA-1.
https://www.uc.solutions/Additional_Solutions/SNOM-PA1/SNOM-PA1_-_Set-up
Updated: Mon, 13 Feb 2023 21:25:19 GMT
Powered by
1
Advertisement
Summary of Contents for Snom SNOM-PA1
- Page 1 The second RJ45 connector labelled "Port 2" is for daisy-chaining further Ethernet devices without the need for another Ethernet cable. Note: If no PoE available: Connect a snom-approved 5 V 10 W power adapter to the power connector labelled "5V DC". (Not included – must be ordered).
- Page 2 (red LED on, green LED off) will damage the firmware and render the PA1 inoperable. In such cases, it will need to be returned to the vendor for resetting. 5. The web interface is available once the Green LED and Red LED are on simultaneously. https://www.uc.solutions/Additional_Solutions/SNOM-PA1/SNOM-PA1_-_Set-up Updated: Mon, 13 Feb 2023 21:25:19 GMT Powered by...
- Page 3 3. Password: ii. Hit “Apply” 6. Test the device by calling the assigned user. The device should auto-answer allowing the caller to “page.” Hang up when page is complete. https://www.uc.solutions/Additional_Solutions/SNOM-PA1/SNOM-PA1_-_Set-up Updated: Mon, 13 Feb 2023 21:25:19 GMT Powered by...